30 SUNFAR C300
C300 series of non-sensor current vector-control inverter manual
Parameters’
Types
Function Code Name Setting range
Minimum
Setting
Manufacture
Setting
Modify
Limit
F5. 0 Multi-speed running mode
The first part of
LED(form right to
left)：PLC setting
0：PLC is invalid. 1：PLC is valid.
2：PLC is conditional invalid.
The second part of
LED：Simple PLC running mode selection
0：Single loop mode
1：Single loop and stop mode
2：Continuous loop mode
3：Continuous loop and stop mode
4：Keep the end value
5：Keep the end value and stop mode
The third part of LED
0：Restart from the first stage freq.
1：Restart from running freq. which is
saved before running is break
2：Restart from setting freq. when
running is break.
The fourth part of LED：PLC save state
0：Non-save after power off
1：Save after power off
1 0000 ★
F5. 1 Multi-speed frequency 1 0.0 ~ the upper limit freq. 0.01 35.00
F5. 2 Multi-speed frequency 2 0.0 ~ the upper limit freq. 0.01 15.00
F5. 3 Multi-speed frequency 3 0.0 ~ the upper limit freq. 0.01 3.00
F5. 4 Multi-speed frequency 4 0.0 ~ the upper limit freq. 0.01 20.00
F5. 5 Multi-speed frequency 5 0.0 ~ the upper limit freq. 0.01 25.00
F5. 6 Multi-speed frequency 6 0.0 ~ the upper limit freq. 0.01 30.00
F5. 7 Multi-speed frequency 7 0.0 ~ the upper limit freq. 0.01 35.00
Multi-speed running parameter unit
F5.8 Multi-speed frequency 8 0.0 ~ the upper limit freq. 0.01 40.00
To Next Page
Loading...
