Sunfar C300 Series - Advanced Running Parameters: Fault Recovery and Timers

32 SUNFAR C300
C300 series of non-sensor current vector-control inverter manual
Parameters’
Types
Function Code Name Setting range
Minimum
Setting
Manufacture
Setting
Modify
Limit
F6.0 Reserved
F6.1 Fault self-recovery time 0，1，2 1 0 ★
F6.2
Interval time of
fault self-recovery
0.2～20 S 0.1 2.0 ★
F6.3
Final value set up of internal
counter
1～60000 1 1 ★
F6.4 Internal timer setup 1～60000 1 1 ★
F6.5 Skip freq. 1 0.0～the upper limit freq. 0.01 0
F6.6
Amplitude accumulation of
Skip freq. 1
0.0～5.00Hz 0.01 0
F6.7 Skip freq. 2 0.0～the upper limit freq. 0.01 0
F6.8
Amplitude accumulation of
Skip freq. 2
0.0～5.00Hz 0.01 0
F6.9
Linear speed
coefficient setting
0.01～100.0 0.01 1
F6.10
Close-loop analog
coefficient setting
0.01～100.00 0.01 1.00
F6.11
Rotator speed
coefficient setting
0.01～10.00 0.01 1.00
F6.12 Monitor item selection 1 0～11 1 0
F6.13 Monitor item selection 2 0～11 1 1
F6.14 Query or modify parameters 0 ~ 9999 1 1700
Advanced running parameter unit
F6.15 Parameter initialization
0：Parameter initialization is off.
1：Parameterinitialization is on.
2：Clean fault records
1 0 ★