2.3 Plugging in and turning on Your Versa6SDPro
TM
First plug the Versa6SD Pro
TM
power cable into the approved outlet as defined in
Section 1.3. The outlet is a twist-lock type. Orient the plug so that the terminals match
with the outlet receptacles. Push the plug all the way in, then twist clock-wise to lock it
in place.
Next, locate the main power switch on the RCBO at the lower left area of the back of the
spray column. Flip the blue lever upward to power on the unit. It will take around 1
minute for the control system to fully load. Once it is loaded, the Home Screen will
appear on the Touchscreen as shown below.
Section 2!
Getting to Know Your Versa6SDPro
TM
12
RCBO/ Main
Power Switch
Down is Off
Serial Number
Label
To Next Page
Loading...