3.5 Smart Container System
Your Versa6SDPro
TM
utilizes a Smart Container System. This innovative system
reads information from each Bag-In-Box solution container to automatically set your
machine to the factory recommended settings for each type of solution. In addition
the Smart Container System provides the following benefits:
Expired Solution: Since the manufacture date and expiration date are stored on
each container, the unit will warn you if you insert an expired container.
Changing solution slot locations: The unit will know if a different type of solution is
inserted into a slot and will notify the operator and determine if the switch is
intentional or was done by mistake. This feature makes it difficult to put the
wrong solution in the wrong slot.
Session Builder and Favorites: Since the controller knows what kind of solutionis
in each slot, the solution name will be shown when selecting Favorites or using
the Session Builder.
Cloud Reporting: Through the Cloud Dashboard, it will be easy to get reports and
see how much of each type of solution is being used.
3.6 Installing and Removing Solutions
Your Versa6SDPro
TM
comes with a solution drawer that can hold up to four different
solution containers in each of the four slots. Slot #1 is closest to the drawer front. It is
recommend to install Bronzer, Clear, Moist, and Prep into slots 1,2,3, and 4 respectively.
To install all Bag-in-Box Solution Containers for the first time it is important to do so
while the machine is powered off. If doing one container only, the machine can be left
on:
1. Go to the Dashboard on the Touchscreen Controller.
2. Input your Admin, Manager, or Staff Password.
3. Click the Unlock Drawer button at the upper-right part of the touchscreen.
4. Pull the drawer open.
5. Turn off power to the machine.
6. Remove the protective cover from the fitting on all of the boxes.
7. Orient the front of the box with the viewing window towards you, line up the fitting
of the box with the mating fitting in the drawer, and using one hand on the lip of
the clip by the fitting and the other on the top of the box, push down until it clicks
in place. Repeat for all 4 boxes.
8. Power the machine back on.
To remove a container: simply lift up on the box by the clip until it snaps out of place.
See the following diagram for slot locations and container orientation:
Section 3! Setup
22
To Next Page
Loading...