6.6 HVLP Blower Filter Cleaning
There is a single filter that cleans the intake air for both the Nozzle HVLP Blower and
the Heater HVLP Blower on the left side of the spray column. This foam filter is
recommended to be cleaned monthly or more often at high usage salons. To remove
the filter, simply pull it out of its holder as shown below, rinse in warm water, squeeze it
out to remove excess water and let dry. Once dry, put back in the machine.
6.7 Sump Pump Basin Cleaning
The water from washing down your Versa6SDPro
TM
will travel through the sump pump
filter basket and into the sump pump basin inside the spray column. When the basin
gets full, the sump pump will pump the water out of the basin and out to the drain.
When water and solution sit in the basin for long periods of time it may need to be
manually cleaned. To clean the sump pump basin:
1. Turn off the power to the machine by pushing down the blue lever on the RCBO.
2. Remove the 4 screws that hold the lower spray column cover in place.
3. Lift the sump pump out of the basin and set aside.
4. Using towels, soak up the residual water in the basin.
5. Using a warm water, clean the basin area and also the under side of the sump
pump, being careful not to bend or damage the components under the pump.
6. Replace sump pump and back spray column cover.
7. Turn Power back on.
Section 6! Maintenance and Cleaning
4
To Next Page
Loading...