6.8 Cleaning and Purging Solution Lines
It may be necessary to use Sunless, Inc.’s Purge Solution to help clean out solution
lines if a machine has been sitting for a long period of time or for periodic maintenance.
See Section 5.3 on Using Purge Solution for instructions.
6.9 Nozzle Cleaning
The nozzles of your VersD6SaPro
TM
will build up with solution over time and it is
recommended that the air caps be removed along with the air cap retainers and rinsed
in warm water once a month. To remove, loosen each of the 3 air cap retainers by
turning counter-clockwise and set aside. Now you can take each air cap out and rinse
with warm water along with the air cap collars. To re-assemble, line up the circular
bump in the nozzle body with the small hole on the back side of the air cap and place
the air cap back in the nozzle body and then hand tighten each of the air cap collars.
See illustration below:
6.10 Powering Down Booth
Just like any electronic device, it is recommended to power down your booth and power
it back up once a week.
6.11 Turning off Water Supply to Booth
It is recommended that the water supply to the booth be shut off nightly in case there is
a faulty valve at the wall or hose coming to the booth to prevent flooding.
6.10 Ordering Replacement Parts
If your Versa6SDPro
TM
needs service or replacement parts, contact Sunless, Inc.’s
Technical Support Department at 1-855-450-3500.
Section 6! Maintenance and Cleaning
To Next Page
Loading...