5.1 Replacing an Empty Solution Container With the Same Type
Your Versa6SDPro
TM
and its Smart Container System instantly recognizes when a
solution container is removed or inserted into any of the 4 solution slots. If you remove
an empty solution container, the controller will sound an audible “beep”, signaling it
has recognized the container is removed. When you replace it with the same type of
solution, the machine will recognize this, sound the audible “beep” again, and display a
notification on the touchscreen that it has recognized the same solution type, then
automatically fill the solution reservoir and is ready to continue.
To open the drawer and replace a solution container:
1. Go to the Dashboard on the Touchscreen Controller.
2. Input your Admin, Manager, or Staff Password.
3. Click the Unlock Drawer button at the upper right part of the touchscreen.
4. Pull the drawer open.
5. Remove the empty container by lifting up on the box by the clip until it snaps out
of place and recycle the old box.
6. Select the Close Button on the message screen that appears.
7. Remove the protective cover from the fitting on the new box.
8. Orient the front of the box with the viewing window towards you, line up the fitting
of the box with the mating fitting in the drawer, and using one hand on the lip of
the clip by the fitting and the other on the top of the box, push down until it clicks
in place.
9. On the next message screen, select the Fill Reservoir button to make sure the
solution reservoir is filled.
10.When the reservoir is filled, a message will be displayed that the new solution is
now ready to use. Select the Finish button and the new container is ready.
11.Close the drawer.
*See Screen Images Below:
Section 5! Adding and Changing Solutions
40
To Next Page
Loading...