7KLVPRGHLVIRUXVHZLWKQRQTmax timer systems that simply apply a closed contact
between two leads connected to the unit. When time is sent to the unit and the
contacts are closed, it allows the salon staff to create and initiate a session using the
Session Builder or Favorites functions from the Home Screen. These buttons will not
be active until time is sent.
•
Pre-Warm: With this enabled, after a session is activated, the heaters will blow warm
air into the booth to help create a warmer environment for the user.
•
Auto-Wash: With this enabled, the booth will automatically wash down after each
session. The duration of wash-down and the time delay before it starts after a session
are described in the parameters below.
•
Auto-Reset: When enabled, the booth will automatically reset after each session and
also send a ready command to the T-Max manager.
•
Booth Wash Duration: This controls how long the wash cycle is for the booth walls
and floor.
•
Fan Column Wash Duration: This controls how long the wash cycle is for inside of
the Fan Column and also the Lifetime Filter. Both will be rinsed and cleaned during
this time.
•
Auto-Wash Start Delay: This controls how much time after the end of a session that
the wash cycle will begin.
•
Height Detection: With Height Detection enabled, at the beginning of each session
the nozzles will come down and detect the height of the user. It will use this height to
automatically adjust the spray starting position for a full body, just face, or just leg
session without the need to manually input the user’s height. With this option
disabled, it will spray the full height of the booth for each user independent of the
user’s height and for face and leg sessions, the user’s height will have to be manually
entered in the touch screen.
•
Dry Passes In-Between Spray: With this enabled, the unit will perform a spray pass
on the way down and with the user still in the same position, it will dry them on the
way up. There can also be additional dry passes added to the end of each treatment
by setting the number in the Session Parameters section for that solution. With this
option disabled, the unit will perform the total number of spray passes consecutively,
then perform the total number of dry passes.
Section 3! Setup
26
To Next Page
Loading...