Sunless VersaSpa Pro - 2-Position Stance

2-Position Stance
Step 1. Once in the Versa6SDPro
TM
application area, make sure the unit is properly
reset by visually checking that the green start button (located on the spray nozzle
column inside the Versa6SDPro
TM
spray booth) is blinking slowly. If the green start
button is not blinking slowly, notify salon operator.
Step 2. If the Versa6SDPro
TM
booth is properly reset (see Step 1), remove jewelry and
makeup, then disrobe. Apply nose filter and lip balm.
Step 3. Put on your hair cap (position cap slightly behind hairline and ears) and foot
coverings (if foot coverings are available and desired).
Step 4. Apply blending lotion to palms (if desired), cuticles of fingers, fingernails,
between fingers, bottom of feet, and between toes (if not using foot protection). Avoid
touching any part of the body after applying blending lotion.
Step 5. Enter the Versa6SDPro
TM
application area.
Step 6. Start in the position 1 stance (see Position #1 figure below), standing with your
toes on #1 and your heels on #.
Step 7. Once in the proper position, press the green start button (located on the spray
column) to initiate the 2 misting cycles and dry cycles
Note: The Versa6SDPro
TM
will perform 2 misting cycles, which correspond to 2
recommended positions (see figures below). The misting cycle lasts approximately 7
seconds and starts from the top and moves down on the first cycle. Next it will begin a
12 second dry pass on the way up while you remain in this position.
Step 8. After the first misting and drying cycle is complete, follow the voice guided
instructions and move to the position 2 stance (see Position #2 figure below) and stand
with your toes on #4 and your heels on #1. It will now spray you on the way down,
pause, and then dry you while the nozzles are moving back up.
Step 9. After the second misting and drying cycle is complete, follow the voice guided
instructions for any additional dry passes. If there are additional dry passes, you will be
guided to remain in this position for the first additional dry pass and then it will guide you
to turn around into position 1 with your toes on #1 and your heels on #4 for your final dry
pass.
Step 10. Exit the Versa6SDPro
TM
and remove hair cap, foot protection, nose filters, and
any other protective items, then discard them.
Step 11. Wipe blending lotion off hands (if used) using a towel or tissue. (To avoid
potential streaking, make sure the towel is not the same one used to remove excess
blending lotion prior to tanning.)
Section 4!
Using Your Versa6SDPro
TM
31