•
Solution Pumps: Allows you to test the function any of the four solution pumps. After
selecting the Pump #, the Pump Volume of solution to be dispensed, the Nozzle
Blower Level (can be set to zero to watch the streams of solution), and the Run Time,
a results page will be displayed.
•
Spray Test: Allows you to run a full spray pass and select which Pump #, the Pump
Volume of solution to be sprayed, the Pass Duration in seconds, the Nozzle Blower
Level, the Heater Blower Level, and the Heater Level. After the test, the results will be
displayed.
Section 7! Advanced Touchscreen Functions
6
Solution Pumps Test Screen SprayTest Screen
To Next Page
Loading...