A.
Press MODE key.
B.
After moving to “4. Machine Test”by using
direction keys , press ENTER key.
C.
After moving to “10. XY-jog Test”by using
direction keys , press ENTER key.
D.
If you press direction keys, the position coordinates
of X and Y shaft and present position among 4
sections moving to a step each.
E.
If you want to finish XY jog Test, press ESC key.
If you want to finish test menu, press ESC key.
F.
Back to the initial screen by pressing ESC key.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
10.XY-Jog Test
11.Solenoid Test
12.Origin Test
X-Y jogging Test
ESC to Exit
X:0000 Y:0000
Xsen:1 Ysen:1
(11) XY Jog Test
It is a test of X Y step motors operation by manual drive.
A.
Press MODE key.
B.
After moving to “4. Machine Test”by using
direction keys , press ENTER key.
C.
After moving to “11. Solenoid Test”by using
direction keys , press ENTER key.
D.
If you press a solenoid number that you want to
test, the relevant solenoid repeats turning on
and off.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
11.Solenoid Test
12.Origin Test
13.Jump Test
1PF On 2FF Of
3TT Of 4Tr Of
5WP Of 6FFL Of
7TS Of 8RV Of
(12) Solenoid Test
It is to test if each solenoid works properly.
To Next Page
Loading...
