6
11
Safety rules for machine
Safety instruction on this manual are defined as Danger, Warning and Notice.
If you do not keep the instructoins, physical injury on the human body and machine damage might be occurred.
: This indication should be observed definitely. If not, danger could be happen during the installation,
conveyance and maintenance of machines.
: When you keep this indication, injury from the machine can be prevented.
: When you keep this indication, error on the machine can be prevented.
CAUTION
WARNING
DANGER
1-1) Machine
Transportation
Danger
1-2) Machine
Installation
Caution
1-3) Machine Repair
Danger
Only trained and experienced people should treat the machine who are fully
understand the safety rules. For conveyance, follow the below directions.
ⓐ More than two people to a minimum should convey the machine.
ⓑ For a protection of safety accident, wipe away the oil stained on machine.
Owing to the improper environment for machine installation, physical damages on the
human body and machine can be occurred. Please follow below conditions.
ⓐ When you unwrap the packing of the machine, try from above in order. Especially
careful of nails put into edges of wood box packing.
ⓑ Since dust and humidity can cause pollution and abrasion, you should install
airconditioner with regular cleaning.
ⓒ Put in a place of no direct ray of light. If the machine is exposed in direct ray of light
for a long time, transformation of color and shape can be happened.
ⓓ To get enough space in case of repair, make the machine 50cm apart from the right
and left and back side of wall to a minimum.
ⓔ EXPLOSION HAZARDS
Do not operate in explosive atmospheres. To avoid explosion, do not operate this
machine in an explosive atomosphere including a place where large quantities of
aerosot spray product are being used or where oxygen is being administered unless
it has been specifically certified for such operation.
ⓕ The machines where not provided with a local lighting due to the feature of machine.
Therefore the illumination of the working area must be fuifilled by end user.
[Note] Details for installation of machine is described in ‘4. Machine Installation.’
If you have any problems on the machine, troubleshooting should be handled by the
designated A/S engineers.
ⓐ Before cleaning and repairing machine, cut off the main power and wait for 4 minutes
until the machine comes to be completely discharged.
ⓑ You should not change the specification of machine and any part of machine without
consulting with our company. Those changes can threaten the safety of machine during
the operation.
ⓒ You should exchange from the used one into SWF guaranteed devices.
ⓓ After finishing troubleshooting, cover the all covers that are uncovered during repairing.
To Next Page
Loading...
Need help?
General
