SUNWARD SWDE120B-3 - IO Port Interface

OPERATION & MAINTENANCE MANUAL SWDE120B-3
18
Icon 4“air compressor parameters display” is the air compressor parameters display
area of the machine. The air compressor engine water temperature, air compressor exhaust
temperature and air compressor engine speed will be shown.
Icon 5“host parameters display” is the host parameters display area of the machine.
The host engine water temperature, fuel volume and air host engine speed will be shown.
The light blue state bar at the top is time and company name.
There F1 to F8 stand for the eight buttons at the left/right of the display. When the operator
presses a key, the system will enter into a corresponding interface.
Press “RETURN”（F1） to enter “instrument home page”，that’s the welcome screen.
Press “PARAMETER”（F2）to enter “parameter interface”(See figure 3.3)，to monitor
meters and sensors.
Press “SET” (F3) to enter “setting interface” (See figure 3.4) to set the parameters.
Press “RESET” (F4), the current drilling depth will be clear, the display will be zero and
the drilling depth will be restarted.
Press “INCLINATION” (F5) to enter “inclination interface” (See figure 3.5) to set the
inclination
Press “DRILLING DEPTH DETECTION”（F6） to enter “drilling depth detection
interface” (See figure 3.6)to set the drilling depth detection.
Press “FAULT CODE” (F7) to enter “fault code interface” (See figure 3.7) to check
the record.
Press “IO PORT” (F8) to enter “controller IO port interface” (See figure 3.8) to check
the controller IO pin data.