Suzuki Intruder VZR1800 - Clutch Release Camshaft

ENGINE 3-51
CLUTCH RELEASE CAMSHAFT
DISASSEMBLY
• Remove the clutch release arm

1, return spring

2 and
washer

3.
• Pull out the oil seal

4, bearing

5 with the clutch release cam-
shaft

6.
"
• Remove the clutch push rod cap

7 and oil seal

8.
"
REASSEMBLY
• Apply SUZUKI SUPER GREASE “A” the release camshaft

1,
new bearing

2 and oil seal

3 before installing.
) 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Install the clutch release arm and tighten the bolt

1.
NOTE:
Align the release arm punch mark

A with the notch mark

B on
the release camshaft.
The removed oil seal and bearing must be replaced
with new one.
The removed oil seal must be replaced with new one.