2-16 PERIODIC MAINTENANCE
SPARK PLUG INSTALLATION
• Screw the spark plugs into the cylinder head with fingers, and
then tighten them to the specified torque.
# Spark plug: 11 N·m (1.1 kgf-m, 8.0 Ib-ft)
"
IGNITION COIL/PLUG CAP INSTALLATION
• Install the ignition coils/plug caps and connect their lead wire
couplers.
"
FUEL LINE
• Inspect the fuel feed hose
1 for damage and fuel leakage. If
any defects are found, the fuel feed hose must be replaced.
EVAPORATIVE EMISSION CONTROL
SYSTEM (E-33 ONLY)
Inspect the evaporative emission control system periodically.
Do not cross thread or over tighten the spark plug, or
such an operation will damage the aluminum threads
of the cylinder head.
* Do not hit the ignition coil/plug cap with a plastic
hammer when installing it.
* Place the ignition coil/spark plug cap so that the cou-
pler does not touch the cylinder head cover.
CONTACT
INCORRECT
INCORRECT
Inspect every 6 000 km (4 000 miles, 12 months).
Inspect every 12 000 km (7 500 miles, 24 months).
To Next Page
Loading...
