9-50 CHASSIS
• Tighten the swingarm pivot pinch bolt.
CUSHION ROD, CUSHION LEVER AND REAR SHOCK
ABSORBER
• Assemble the cushion rod, cushion lever and rear shock
absorber onto the swingarm. (!9-46)
• Tighten the rear shock absorber front mounting nut to the
specified torque.
# Rear shock absorber mounting nut:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Tighten the cushion rod nut
1 to the specified torque.
# Cushion rod mounting nut:
110 N·m (11.0 kgf-m, 79.5 lb-ft)
• Tighten the cushion lever mounting nuts
2 and
3 to the
specified torque.
# Cushion lever mounting nut
2: 110 N·m (11.0 kgf-m, 79.5 lb-ft)
3: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• Tighten the rear shock absorber rear mounting nut
4 to the
specified torque.
# Rear shock absorber mounting nut:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Install the final gear case. (!4-28)
• Install the rear wheel. (!9-39)
• Install the exhaust pipes and mufflers. (!7-10)
SUSPENSION SETTING
After installing the rear suspension, adjust the spring pre-load as
follows.
Spring pre-load adjuster (STD) 4th
To Next Page
Loading...
