3-46 ENGINE
PRIMARY DRIVE GEAR BEARING
• Inspect the needle bearing for abnormal noise, wear and
damage. If necessary, replace it with a new one.
GEARSHIFT COVER
DISASSEMBLY
• Remove the gearshift shaft oil seal
1.
• Remove the bearing with the special tools.
% 09921-20210: Bearing remover
09930-30104: Sliding shaft
REASSEMBLY
• Install the bearing
1 and oil seal
2 with the special tool.
% 09913-70210: Bearing installer set (22 mm)
• Apply SUZUKI SUPER GREASE “A” to the oil seal lip.
) 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
"
Use a new oil seal to prevent oil leakage.
To Next Page
Loading...
