DRIVELINE/AXLE 4-9
• Install the oil seal with the special tool.
# 099
13-70210: Bearing installer set (62 mm)
• Apply SUZUKI SUPER GREASE “A” to the oil seal lip.
' 9
9000-25010: SUZUKI SUPER GREASE “A”
or equivalent
SECONDARY DRIVEN BEVEL GEAR
• Install the secondary driven gear
1.
NOTE:
When install the secondary driven gear, fit the convex parts
A of
the secondary driven gear onto the concave parts
B of the out-
put cam dog.
• Tighten the bearing stopper to the specified torque with spe-
c
ial tool.
! S
econdary driven gear bearing stopper:
105 N·m (10.5 kgf-m, 76.0 lb-ft)
# 099
24-41830: Bearing retainer wrench
• Lock the bearing stopper with a center punch.
• Tighten the coupling nut to the specified torque with the spe-
c
ial tool.
! S
econdary driven bevel gear coupling nut:
95 N·m (9.5 kgf-m, 68.5 lb-ft)
# 099
24-64510: Final drive coupling holder
• Lock the coupling nut with a center punch.
• Install the shims
2. ("4-12)
• Apply SUZUKI SUPER GREASE “A” to the O-ring.
' 9
9000-25010: SUZUKI SUPER GREASE “A”
or equivalent
$
Use a new O-ring to prevent to oil leakage.
To Next Page
Loading...
