4-12 DRIVELINE/AXLE
• If tooth contact is found to be incorrect, the shims of the sec-
ondary drive bevel gear and secondary driven bevel gear
must be changed, tooth contact should be re-checked until
correct.
$
SHIM SPECIFICATIONS
Drive bevel gear side
NOTE:
The shims (drive bevel gear side) are available as a set
(
24935-48810).
Driven bevel gear side
NOTE:
The shims (driven bevel gear side) are available as a set
(
24945-26810).
After the tooth contact adjustment is made, the back-
la
sh must be re-checked, as it may change. Refer to
the backlash checking sub-section, and readjust until
both backlash and tooth contact are correct.
Tooth contact Shim adjustment
Contact at tooth top
1
Decrease thickness of shims
4 or
5
Contact at tooth root
3
Increase thickness of shims
4 or
5
Part number Thickness
24935-48G00-040 0.40 mm (0.016 in)
24935-48G00-045 0.45 mm (0.018 in)
24935-48G00-050 0.50 mm (0.020 in)
24935-48G00-055 0.55 mm (0.022 in)
24935-48G00-060 0.60 mm (0.024 in)
24935-48G00-065 0.65 mm (0.026 in)
24935-48G00-070 0.70 mm (0.028 in)
24935-48G00-075 0.75 mm (0.030 in)
24935-48G00-080
0.80 mm (0.031 in)
3 INCORRECT (Contact at tooth root)
Part number Shim thickness
24945-26D00-030 0.30 mm (0.012 in)
24945-26D00-035 0.35 mm (0.014 in)
24945-26D00-040 0.40 mm (0.016 in)
24945-26D00-050 0.50 mm (0.020 in)
24945-26D00-060
0.60 mm (0.024 in)
To Next Page
Loading...
