FI SYSTEM DIAGNOSIS 5-45
Step 3
1) Connect the TP sensor coupler
1 to the test harness.
2) Turn the ignition switch ON.
3) Measure the TP sensor output voltage at the coupler
(between
+ P/B and
- B/Br) by turning the throttle grip.
$ TP sensor output voltage
Throttle valve is closed: Approx. 1.1 V
Throttle valve is opened: Approx. 4.3 V
! 09900-25008: Multi-circuit tester set
& Tester knob indication: Voltage (')
Is the voltage OK?
4) After repairing the trouble, clear the DTC using SDS tool.
(#5-26)
V
3
ECM
TPS
P/B
R
B/Br
3
YES
• P/B, Red or B/Br wire open or shorted to
ground, or poor
8,
A or
S connection
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
If check result is not satisfactory, replace TP sen-
sor with a new one.
ECM coupler (Harness side)
3
(Black) (Gray)
To Next Page
Loading...
