EMISSION CONTROL INFORMATION 12-7
• Check the resistance between the terminals of the PAIR con-
trol solenoid valve.
" Resistance: 18 – 22 Ω at 20 – 30 °C (68 – 86 °F)
# 09900-25008: Multi-circuit tester set
$ Tester knob indication: Resistance (Ω)
INSTALLATION
If the resistance is not within the standard range, replace the
PAIR control solenoid valve with a new one.
Installation is in the reverse order of removal. Pay attention to
the following points:
• Install the PAIR control solenoid valve to the air cleaner
chamber.
• Apply thin coat of the engine oil to the new O-rings.
%
• Connect the PAIR control solenoid valve lead wire coupler
and PAIR hoses securely.
• PAIR system hose routing (!12-8 to -9)
Replace the O-rings with the new ones.
To Next Page
Loading...
