3-4 ENGINE
• Disconnect the ECT sensor lead wire coupler
4.
• Disconnect the ignition coil/plug cap lead wire couplers and
remove the ignition coils/plug caps. (!2-13 and -14)
"
• Disconnect the spark plug caps. (!2-13 and -14)
• Disconnect the radiator inlet hose
5.
• Remove the rear brake fluid reservoir mounting bolt
6.
• Remove the master cylinder cover
7.
* Do not remove the ignition coil/plug cap before dis-
connecting its coupler.
* Do not pry up the ignition coil/plug cap with a screw
driver or a bar to avoid its damage.
* Be careful not to drop the ignition coil/plug cap to
prevent its short or open circuit.
#1
#2
To Next Page
Loading...
