REAR SUSPENSION 3E-19
Rear Axle Housing (for 4WD Model)
Removal
1) Hoist vehicle and remove rear wheels referring to “Wheel
Removal and Installation” in Section 3F.
2) Remove rear axle shafts (right & left) referring to Steps 2) –
9) of “Rear Axle Shaft and Wheel Bearing (for 4WD Model)”
in this section.
3) Disconnect brake pipes (2) (right & left) from flexible hoses
(1) and remove E-rings (3).
4) Remove brake pipes from wheel cylinders (right & left).
5) Remove wheel speed sensors (right & left) and release
clamps from axle housing (if equipped with ABS).
6) Remove LSPV adjust nut and detach spring end from rear
axle housing (if equipped with LSPV).
7) Before removing propeller shaft, give match marks (1) on
joint flange and propeller shaft (2) as shown.
8) Remove propeller shaft.
9) For jobs hereafter, support rear axle housing by using floor
jack (1) under axle housing (2) and remove differential car-
rier assembly.
10) Remove lateral rod (1).
To Next Page
Loading...
