7C-6 CLUTCH (G10/M13 ENGINES)
Clutch Cover, Clutch Disc and Flywheel
REMOVAL
1) Dismount transaxle assembly referring to “Transaxle unit
Dismounting and Remounting” in Section 7A.
2) Hold flywheel with special tool and loosen clutch cover bolts
(1). Remove clutch cover (2) and clutch disc.
Special tool
(A): 09924-17810
[A]: M13 engine 7. Clutch release shaft No.1 bush
: Apply grease 99000-25010 to bush inside. (0.3 g (0.01 oz))
[B]: G10 engine 8. Release bearing
: Apply grease 99000-25010 to joint of bearing and release shaft
and also bearing inside. (0.3 g (0.01 oz))
1. Flywheel 9. Clutch cover
2. Flywheel bolt 10. Clutch disc
3. Clutch release shaft seal
: Apply grease 99000-25010 to seal lip. (0.3 g (0.01 oz))
11. Clutch cover bolt
4. Clutch release shaft No.2 bush
: Apply grease 99000-25010 to bush inside. (0.3 g (0.01 oz))
Tightening torque
5. Return spring Do not reuse.
6. Clutch release shaft
Apply grease 99000-25010 to the end of release shaft arm. (0.3 g
(0.01 oz))
To Next Page
Loading...
