6A2-50 ENGINE MECHANICAL (M13 ENGINE)
Camshaft, Tappet and Shim Components
Camshaft, Tappet and Shim Removal and
Installation
Removal
1) Remove timing chain cover referring to “Timing Chain Cover
Removal and Installation” in this section.
2) Remove timing chain referring to “Timing Chain and Chain
Tensioner Removal and Installation” in this section.
1. Intake camshaft 5. Shim
: Shim No. on it faces tappet side.
9. Upper camshaft bearing
: Install a bearing half with some holes to
upper side of intake camshaft No.1 bearing.
2. Intake camshaft sprocket assembly 6. Tappet Tightening torque
3. Intake camshaft sprocket bolt 7. Camshaft housing Apply engine oil to sliding surface of each
part.
4. Exhaust camshaft 8. Camshaft housing bolt
Tighten 11 N·m (1.1 kg-m, 8.0 lb-ft) by
the specified procedure.
CAUTION:
• Keep working table, tools and hands clean while over-
hauling.
• Use special care to handle aluminum parts so as not to
damage them.
• Do not expose removed parts to dust. Keep them
always clean.
To Next Page
Loading...
