FRONT SUSPENSION 3D-5
• Install mounting bracket (1) so that its oblong hole side (2)
comes to the rear.
• Tighten stabilizer bar bracket bolts to specified torque.
Tightening torque
Stabilizer bar bracket bolt: 45 N
·
m (4.5 kg-m, 32.5 lb-ft)
• After tightening castle nut (1) to specified torque, install new
split pin (2) as shown.
Tightening torque
Castle nut
(a): 50 – 150 N
·
m (5.0 – 15.0 kg-m, 36.5 – 108.5 lb-ft)
• Install wheels and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (a): 95 N
·
m (9.5 kg-m, 69.0 lb-ft)
Strut Assembly
Installation
• Install strut assembly by reversing removal procedure.
• Torque all fasteners to specification.
Tightening torque
Strut support nut: 23 N·m (2.3 kg-m, 17.0 lb-ft)
Strut bracket bolt:
115 N
·
m (11.5 kg-m, 83.5 lb-ft)
CAUTION:
• Don’t twist brake hose when installing it.
• Install E-ring as far as it fits to bracket.
To Next Page
Loading...
