7B1-16 AUTOMATIC TRANSAXLE (M13 ENGINE)
Automatic Transaxle Diagnostic Flow Table
Refer to the following items for the details of each step.
Step Action Yes No
1 Customer Complaint Analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed
according to instruction?
Go to Step 2. Perform customer com-
plaint analysis.
2 Diagnostic Trouble Code (DTC)/Freeze Frame
Data Check, Record and Clearance
1) Check for DTC referring to the followings.
Is there any DTC(s)?
1) Print DTC or write
them down and clear
them by referring to
“DTC Clearance” in
this section.
2) Go to Step 3.
Go to Step 4.
3 Visual Inspection
1) Perform visual inspection referring to the fol-
lowings.
Is there any faulty condition?
1) Repair or replace mal-
function part.
2) Go to Step 11.
Go to Step 5.
4 Visual Inspection
1) Perform visual inspection referring to the fol-
lowings.
Is there any faulty condition?
1) Repair or replace mal-
function part.
2) Go to Step 11.
Go to Step 8.
5 Trouble Symptom Confirmation
1) Confirm trouble symptom referring to the fol-
lowings.
Is trouble symptom identified?
Go to Step 6. Go to Step 7.
6 Rechecking and Recording of DTC
1) Recheck for DTC referring to “DTC Check” in
this section.
Is there any DTC(s)?
Go to Step 9. Go to Step 8.
7 Rechecking and Recording of DTC/Freeze
Frame Data
1) Recheck for DTC referring to “DTC Check” in
this section.
Is there any DTC(s)?
Go to Step 9. Go to Step 10.
8 Automatic Transaxle Basic Inspection and Trou-
ble Diagnosis Table
1) Check and repair according to “A/T Basic
Check” and “Trouble Diagnosis Table” in this
section.
Are check and repair complete?
Go to Step 11. 1) Check and repair
malfunction part(s).
2) Go to Step 11.
9 Troubleshooting for DTC
1) Check and repair according to applicable
DTC Flow Table.
Are check and repair complete?
Go to Step 11. 1) Check and repair
malfunction part(s).
2) Go to Step 11.
10 Check for Intermittent Problems
1) Check for intermittent problems referring to
the followings.
Is there any faulty condition?
1) Repair or replace mal-
function part(s).
2) Go to Step 11.
Go to Step 11.
To Next Page
Loading...
