LIGHTING SYSTEM 8B-3
On-Vehicle Service
Rear Fog Light
Rear fog light circuit
Inspection
1) Check headlights and front fog lights (if equipped) come on.
If headlight and/or fog light does not come on, check for light
controller circuit as follows.
2) Disconnect negative cable at battery.
3) Disconnect rear fog controller (1) coupler and connect nega-
tive cable at battery.
4) Check that the voltage and resistance between following ter-
minals are specifications.
If check result is not satisfactory, repair.
[A]: The illustration shows LH steering vehicle.
And RH steering vehicle is symmetrical.
2. Fuse box
Terminals Condition Specification
G53-2 and
ground
– Continuity
G53-4 and
ground
– 10 – 15 V
G53-5 and
ground
When front fog lights come on 10 – 15 V
When front fog lights do not
come on
0 V
G53-6 and
ground
– Continuity
When rear fog light bulb is
removed
No continuity
G53-7 and
ground
When rear fog light switch is
pushed
10 – 15 V
When rear fog light switch is
free
0 V
G53-8 and
ground
When headlight switch is in
OFF
10 – 15 V
When headlight switch is in ON 0 V
G53-7
G53-4
G53-5
G53-2
G53-6
G53-8