Suzuki Wagon R Plus RB413 - Special Tool Set Distance (Reference)

7F-12 REAR DIFFERENTIAL
1) Assemble bearing form dummy with dummy shaft using spe-
cial tools.
Special tool
(A): 09922-76120
(B): 09922-76230
2) Install dial gauge (1) to bearing form dummy with dummy
shaft as shown in figure.
Special tool set distance (reference)
“c”: 2 – 3 mm (0.079 – 0.118 in.)
3) Assemble pinion form dummy using special tools.
Special tool
(A): 09922-76140
(B): 09922-76410
4) Apply gear oil to drive bevel pinion rear bearing, install rear
bearing to pinion form dummy and then install pinion form
dummy to differential carrier.
5) Apply gear oil to drive bevel pinion front bearing and install
bearing to pinion form dummy with other special tools as
shown in figure.
Special tool
(A): 09922-76320
(B): 09922-76150
(C): 09922-76340
(D): 09922-76410
(E): 09922-76140
NOTE:
This installation requires no spacer or oil seal.