7B1-98 AUTOMATIC TRANSAXLE (M13 ENGINE)
Output Shaft Speed Sensor (VSS)
Inspection
1) Connect positive cable of 12 volt battery to “A” terminal of
sensor and ground cable to “C” terminal. Then using voltme-
ter, check voltage between “B” terminal and “C” terminal with
output shaft speed sensor (VSS) driven gear rotated.
If measured voltage (pulse signal) is not as specified,
replace sensor.
Output shaft speed sensor (VSS) output voltage
Pulse signal of alternating 0 – 1 V and 10 – 14 V
2) Check output shaft speed sensor (VSS) driven gear (1) for
wear.
Replace if necessary.
Removal
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Remove output shaft speed sensor (VSS) (1) by removing its
bolt.
Installation
1) Apply A/T fluid to output shaft speed sensor O-ring.
2) Install output shaft speed sensor (VSS) (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor (VSS) bolt
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
3) Connect output shaft speed sensor connector (2) to output
shaft speed sensor (1).
4) Connect negative cable to battery.
To Next Page
Loading...
