ENGINE MECHANICAL (M13 ENGINE) 6A2-17
Air Cleaner Element Inspection and Cleaning
• Check air cleaner element for dirt. Replace excessively dirty
element.
• Blow off dust by compressed air from air outlet side of ele-
ment.
Knock Sensor Removal and Installation
Refer to “Knock Sensor Removal and Installation” in Section 6E2.
Cylinder Head Cover Removal and Installa-
tion
Removal
1) Disconnect negative cable at battery.
2) Disconnect MAF sensor coupler (1).
3) Remove EVAP canister purge valve (2).
4) Remove air cleaner case (3) and resonator (4).
5) Remove cylinder head upper cover (5).
6) Disconnect ignition coil couplers (1).
7) Remove ignition coil assemblies (2) with high-tension cord
(3).
8) Remove wire harness clamp (4) from cylinder head cover.
4
5
3
1
2
To Next Page
Loading...
