ENGINE AND EMISSION CONTROL SYSTEM (M13 ENGINE) 6E2-39
Mass air flow (MAF) and intake air temperature (IAT)
sensor removal and installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect MAF and IAT sensor coupler (1).
3) Remove MAF and IAT sensor (2) from air cleaner assembly.
Installation
Reverse removal procedure noting the followings.
• Tighten MAF and IAT sensor screws to specified torque.
Tightening torque
MAF sensor screw (a): 2.5 N·m (0.25 kg-m, 1.8 lb-ft)
• Connect MAF and IAT sensor coupler securely.
CAUTION:
• Do not disassemble MAF and IAT sensor.
• Do not expose MAF and IAT sensor to any shock.
• Do not cleansing MAF and IAT sensor.
• If MAF and IAT sensor has been dropped, it should be
replaced.
• Do not below compressed air by using air gun or the
like.
• Do not put finger or any other object into MAF and IAT
sensor. Malfunction may occur.
2
1
(a)
To Next Page
Loading...
