3D-4 FRONT SUSPENSION
On-Vehicle Service
Stabilizer Bar and/or Bushings
Components
Installation
For installation, reverse removal procedure, observing the follow-
ing instructions.
• Install stabilizer bar (1) so that paint mark (2) on it comes to
the right side of vehicle.
• Align the outside edge (1) of mount bushing with the inside
edge (2) of paint as shown in figure.
1. Split pin 4. Stabilizer bar bushing 7. Mount bushing 10. Paint mark Tightening torque
2. Castle nut 5. Suspension control arm 8. Mount bush bracket 11. Paint mark (RH side) Do not reuse.
3. Stabilizer bar washer 6. Stabilizer bar 9. Mount bracket bolt
To Next Page
Loading...
