6A2-18 ENGINE MECHANICAL (M13 ENGINE)
9) Remove oil level gauge (1).
10) Disconnect PCV hose (2) from PCV valve (3) and disconnect
breather hose (4) from cylinder head cover.
11) Remove cylinder head cover mounting bolts in such order as
indicated in figure.
12) Remove cylinder head cover (1) with cylinder head cover
gasket (2) and spark plug hole gasket (3).
Installation
1) Install new spark plug hole gaskets (1) and new cylinder
head cover gasket (2) to cylinder head cover (3) as shown in
figure.
2) Remove oil, old sealant and dust from sealing surface on cyl-
inder head and cover. After cleaning, apply sealant “A” to the
following point.
• Cylinder head cover gasket (1) sealing surface area (2) as
shown.
“A”: Sealant 99000-31250
To Next Page
Loading...
