FRONT DRIVE SHAFT (G10/M13 ENGINES) 4A-9
1) Remove differential side boot big band (1) as follows.
• For boot big band without joint
Remove boot big band by tapping boot and band with plastic
hammer.
If it is hard to remove boot big band, cut it using a nipper or a
iron saw with care not to damage tripod joint housing.
• For boot big band with joint
Draw hooks of boot big band together and remove band.
2) Take out tripod joint housing (2).
3) Wipe off grease from shaft and take off snap ring (1) by
using special tool.
Special tool
(A): 09900-06107
4) Remove spider (1) by using 3 arms puller (2).
5) Remove differential side boot small band, then pull out differ-
ential side boot from shaft.
6) Pull out damper through shaft, if equipped.
[A]: For boot big band without joint
[B]: For boot big band with joint
CAUTION:
To prevent needle bearing of joint from being degreased,
do not wash it if it is to be reused.
To Next Page
Loading...
