MANUAL TRANSAXLE (M13 ENGINE) 7A2-7
4) Remove oil seal (1) and install a new one until it becomes
flush with case surface using special tool and hammer.
Special tool
(A): 09913-75510 (2WD and LH of 4WD)
(A): 09951-46010 (RH of 4WD)
5) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal contacts and make sure of its smooth-
ness.
“A”: Grease 99000-25010
6) Install transfer referring to “Transfer Dismounting and
Remounting” in Section 7D.
7) Insert front drive shafts referring to “Drive Shaft Assembly
Removal and Installation” in Section 4A.
8) Install ball stud and stabilizer mount brackets referring to
“Wheel Hub and Steering Knuckle Removal and Installation”
and “Stabilizer Bar and Bushings Removal and Installation”
in Section 3D.
9) Install tie-rod end referring to “Suspension Control Arm/
Bushing Removal and Installation” in Section 3B.
10) Fill transaxle oil as specified referring to “Manual Transaxle
Oil Change” in this section, and make sure that oil has been
sealed with oil seal.
NOTE:
When installing oil seal, face its spring side inward.
To Next Page
Loading...
