MANUAL TRANSAXLE (M13 ENGINE) 7A2-29
Assembly
1) If input shaft oil seal (1) has been removed, install it with its
spring side facing upward.
Use special tool and hammer for installation and apply
grease to oil seal lip.
“B”: Grease 99000-25010
Special tool
(A): 09951-76010
2) If counter shaft right bearing outer race (2) has been
removed, install it using special tools and hammer.
Special tool
(B): 09924-74510
(C): 09925-68210
3) If input oil gutter (1) has been removed, install it with bolt to
which thread lock cement have been applied.
“A”: Thread lock cement 99000-32110
Tightening torque
Oil gutter bolt (a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
4) Install counter shaft left bearing outer race into case bore
tapping it with plastic hammer lightly.
NOTE:
Before installation, wash each part and apply specified
transaxle oil to sliding faces of bearing and gear.
To Next Page
Loading...
