Swan Analytical Instruments AMI Turbiwell - Maintenance (Main Menu 3)

A-96.250.511 / 091120
AMI Turbiwell
Program Overview
82
8.3. Maintenance (Main Menu 3)
I/O State Alarm Relay 2.4.1* * Menu numbers
2.4* Relay 1/2 2.4.2*
Input
Signal Output 1/2
Interface Protocol 2.5.1* (only with RS485
2.5* Baud rate interface)
Verification SWAN VERIKIT # 3.1.1*
3.1* Other Method 3.1.2*
Matching Solid Verikit SWAN VERIKIT # 3.2.1.1*
3.2* 3.2.1* Follow screen instructions
Liquid Verikit SWAN VERIKIT # 3.2.1.2*
3.2.2* Follow screen instructions
Calibration Calibration Progress If FNU/NTU is selected
3.32* 3.32.1*
Simulation Alarm Relay 3.4.1*
3.4* Relay 1 3.4.2*
Relay 2 3.4.3*
Signal Output 1 3.4.4*
Signal Output 2 3.4.5*
Set Time (Date), (Time)
3.5*
Drainage Manual operation Motor valve
3.6* 3.6.1* 3.6.1.1
Parameters Mode 3.6.2.1*
3.6.2* Start Time 3.6.2.2*
Duration 3.6.2.3*
Delay 3.6.2.4*
Signal outputs 3.6.2.5*
Output/Control 3.6.2.6*