Swan Analytical Instruments AMI Turbiwell - Operation (Main Menu 4)

A-96.250.511 / 091120
AMI Turbiwell
Program Overview
83
If the unit ppm is selected
8.4. Operation (Main Menu 4)
Process Cal. ppm Detect Zero 3.1.1* * Menu numbers
3.1* Specify Slope 3.1.2*
Simulation
3.2*
Set Time
3.3*
Drainage
3.4*
Sensors Filter Time Const. 4.1.1*
4.1* Hold after Cal. 4.1.2*
Relay Contacts Alarm Relay Alarm Alarm High 4.2.1.1.1*
4.2* 4.2.1* 4.2.1.1* Alarm Low 4.2.1.1.25*
Hysteresis 4.2.1.1.35*
Delay 4.2.1.1.45*
Relay 1&2 Setpoint 4.2.x.100*
4.2.2* & 4.2.3* Hysteresis 4.2.x.200*
Delay 4.2.x.30*
Input Active 4.2.4.1*
4.2.4* Signal Outputs 4.2.4.2*
Output / Control 4.2.4.3*
Fault 4.2.4.4*
Delay 4.2.4.5*
Logger Log Interval 4.3.1*
4.3* Clear Logger 4.3.2*