Scanner Emulation Interface 10 - 3
Scanner Emulation Parameter Defaults
Table 10-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on page 10-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 10-1
Scanner Emulation Default Table
Parameter Default Page Number
Beep Style Beep on Successful Transmit 10-4
Parameter Pass-Through Parameter Process and Pass Through 10-5
Convert Newer Code Types Convert Newer Code Types 10-6
Module Width 20 µs 10-7
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39 10-7
Code 39 Full ASCII Conversion Disable 10-8
Transmission Timeout 3 Sec 10-9
Ignore Unknown Characters Ignore Unknown Characters 10-10
Leading Margin 2 ms 10-10
Check for Decode LED Check for Decode LED 10-11
1
User selection is required to configure this interface and this is the most common
selection.
To Next Page
Loading...
