Standard Default Parameters A - 3
USB CAPS Lock Override Disable
7-8
USB Ignore Unknown Characters Send
7-9
Emulate Keypad Disable
7-9
USB FN1 Substitution Disable
7-10
Function Key Mapping Disable
7-10
Simulated Caps Lock Disable
7-11
Convert Case No Case Conversion
7-11
IBM 468X/469X Host Parameters
Port Address None Selected
8-4
Convert Unknown to Code 39 Disable
8-5
Ignore Beep Disable
8-6
Ignore Bar Code Configuration Disable
8-6
Wand Emulation Host Parameters
Wand Emulation Host Types
Symbol OmniLink Interface Controller
1
9-4
Leading Margin 80 msec
9-5
Polarity Bar High/Margin Low
9-6
Ignore Unknown Characters Send
9-6
Convert All Bar Codes to Code 39 Disable
9-7
Convert Code 39 to Full ASCII Disable
9-8
Scanner Emulation
Beep Style Beep on Successful Transmit
10-4
Parameter Pass-Through Parameter Process and Pass Through
10-5
Convert Newer Code Types Convert Newer Code Types
10-6
Module Width 20 µs
10-7
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39
10-7
Code 39 Full ASCII Conversion Disable
10-8
Transmission Timeout 3 Sec
10-9
Ignore Unknown Characters Ignore Unknown Characters
10-10
Table A-1
Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
