Symbol MC1000 - Battery Charging; Cables

Accessories 3-7
Battery Charging
Re-chargeable AAA batteries do not charge in the mobile computer when the mobile computer is placed in
the Four Slot USB cradle.
To charge the battery for your mobile device, battery and charger temperatures must be between +32° F and
+104° F (0° C to +40° C).
UConnect software must be loaded onto the mobile computer for proper ActiveSync operation. Refer to the
MC1000 Integrator Guide for installing UConnect onto the mobile computer.
The Four Slot USB cradle can charge up to four mobile computers simultaneously. The Li-ion battery charges in approximately four
hours. To charge the mobile computer:
1. Connect the Four Slot USB cradle to a power source.
2. Firmly press the mobile computer into the mobile computer slot.
3. The mobile computer’s Charge LED indicates the mobile computer battery charging status.
4. When charging is completed, hold the cradle with one hand and lift the mobile computer out of the cradle with the other
hand.
Cables
This section describes how to set up and use the cables. The cables:
• provide the mobile computer’s operating power and battery charging power when used with the Symbol approved power
supply.
• provide serial connection through the serial pass-through port for communication with a serial device, such as a host
computer. For communication setup procedures, refer to the MC1000 Integrator Guide.
• provide USB connection through the USB pass-through port for communication with a USB device, such as a host computer.
For communication setup procedures, refer to the MC1000 Integrator Guide.
• provide printing capabilities to an approved printer.
Use only a Symbol-approved power supply output rated 5.4 VDC and minimum 3 A. The power supply is
certified to EN60950 with SELV outputs. Use of alternative power supply will invalidate any approval given
to this device and may be dangerous.
Benutzen Sie nur eine Symbol Technologies genehmigt in den Ausgabe: 5.4 VDC und minimum 3A. Die
Stromversorgung ist bescheinigt nach EN60950 mit SELV Ausgaben. Bei Verwendung eines anderen Netzteils
werden alle für das Gerät gewährten Genehmigungen außer Kraft gesetzt, und der Betrieb kann gefährlich
sein.