Maintenance & Troubleshooting 4-5
The mobile computer does not
accept scan input.
Scanning application is not
loaded.
Verify that the mobile computer is loaded with a scanning application. See the system
administrator.
Unreadable bar code. Ensure the symbol is not defaced.
Distance between exit
window and bar code is
incorrect.
Ensure mobile computer is within proper scanning range.
Mobile computer is not
programmed for the bar code
type.
Ensure the mobile computer is programmed to accept the type of bar code scanned.
Mobile computer is not
programmed to generate a
beep.
Check that the application is set to generate a beep on good decode.
Battery is low. Check the battery level. When the battery is low, the mobile computer automatically goes
into suspend mode.
Table 4-1. Troubleshooting the Mobile Computer (Continued)
Problem Cause Solution
To Next Page
Loading...
