SYMC BC360 - Weight Calibration Menu; Enter Weight Calibration Menu; Weight Calibration

24
F3.1=2 Auto print
1 Select batching report output
2 Enter
report
 Batching mode 4（auto feeding / auto Dump）
Press [SELECT] key to select operating menu and press [ENTER] to execute selected menu
command.
Display list
Instruction
Required parameters
run
Enter into batching menu
F6.6=0
，
F6.7= 0
rEPort
Print last batching report
F3.1=1or 2，and one batching
process is finished.
AccPrt
Print consumption list of output
material (when printing finished,
it reminds AccClr, asking if clear
total data. And clear data by
press ENTER key, or pressing
ZERO key to give up.
F3.1=1or 2
Display menu under batching condition
Display list
Instruction
Required parameters
HoLd
Press [Enter] to hold the batch
processing if this “Hold” prompt
display.
A material is feeding or Dumping
out
Display menu under batching suspended condition
Display list
Instruction
Required parameters
run
Continue un-finished work
StoP
Stop un-finished batching work
Auto feeding / auto Dump operation: