Other instruction during batching process.
1
、
If formula data (all data is zero), indicator shows “noSHEt” when start.
If formula data is wrong, indicator shows “SHt.Err” when start. for example: one material data is
nonzero
，
but not meet
(
tArGet
)≥
(FiNE
) ≥
(PrEACt
)
rules. If the material target is 0,
terminal skips this material target check.
2
、
If the terminal is power on with F6.10=1, and last batching process is not finished, the
upper window will show “Go oN”. Press [Select] for “Yes” or “No” to continue last
unfinished process or cancel the unfinished process.
3、 if the pre-set quantitative batch data [bAtcH] ＞0, and the times of batching cycle reach
the preset value, terminal will display “End” when starting the procedure.
1 Select batching report output
To Next Page
Loading...