TMSL 097-45018-02 Issue 3: Mar 96
Page 48
RETRIEVE ALARMS (Contd)
condtype: FA = fuse alarm
SYNCCLK = output port failed
HLDOVRSYNC = clock in the holdover mode
SYNC = input reference failed
FRNGSYNC = clock in the freerunning mode
SLTMSIG = input references unlocked
INT = card failed
FSTSYNC = clock in the fast-converge mode
BPV = bipolar violations
CRC = cyclic redundancy check errors
OOF = out of frame errors
LOS = loss of signal
AIS = alarm indication signal
<null> = all of the above condtypes
Note: If the aid is MRC-1 or MRC-2, the condtypes AIS, BPV, CRC, OOF, and LOS are
to be used only if E1 is selected as the input; if analog is the input, and AIS, BPV, CRC,
OOF, or LOS are the condition types, the command will be denied.
condtype: For PSM only:
MTIE1 = maximum time interval error at 1 second
MTIE4 = maximum time interval error at 4 seconds
MTIE16 = maximum time interval error at 16 seconds
MTIE64 = maximum time interval error at 64 seconds
MTIE128 = maximum time interval error at 128 seconds
MTIE512 = maximum time interval error at 512 seconds
MTIE900 = maximum time interval error at 900 seconds
TVAR1 = time variance error at 1 second
TVAR4 = time variance error at 4 seconds
TVAR16 = time variance error at 16 seconds
TVAR64 = time variance error at 64 seconds
TVAR128 = time variance error at 128 seconds
<null> = all condtypes, except those listed for GTI
condtype: For GTI only:
FA = fuse A
FB = fuse B
GPSLOS = GPS loss of signal
GPSINVLD = GPS timing is invalid
GTINOINPUTS = no oscillator A or B and no GPS
GTIOUTFLT = output of the GTI has been faulted
GTIFAILx = hard failure, where x = 1 through 5 (the numbers 1-5 are
diagnostic codes for field service/engineering use only)
OSCALOS = no OSC A input
OSCBLOS = no OSC B input
OSCATOL = OSC A out of tolerance
OSCBTOL = OSC B out of tolerance
GTRPWR = power supply has been faulted by a short, an open, or
equipment failure
GTRFREQTOL = 4 kHz output from the GTR is not phase-locked
GTRSAT = insufficient satellites
To Next Page
Loading...
Need help?
General
