66
|
4. Mount the middle rail (pos 9) longitudinally at the centre-line of the unit with self drilling screws (pos 7). Middle
rail is delivered only for units size 16 and higher.
5. Place all trapezoidal roof sheets (pos 6) on rails, mount overhang plates (pos 5) under trapezoidal roof sheets at
each end of the unit. Sheets have to be placed on top of each other by overlapping two crests (pos A). Last two
sheets may overlap by more than two crests to match the length of the roof (pos B).
6. Position the roof so that the roof overhang profiles would be sticking out roughly 200 mm at sides and 100 mm at
the front and back as show in the illustration bellow.
211728 | v7.2
To Next Page
Loading...
