40 User Function Menu
Exiting Call Diversion Mode
To leave call diversion mode or call diversion setup
mode, press another mode key (function, call, sta-
tus, channel or alphanumeric).
Receiving a Call During Call Diversion
When a standard incoming call is received by the
radio in call diversion mode, the programmed auto-
acknowledgement sequence is transmitted, as for a
normal call. However the programmed diversion
status is transmitted instead of the normal acknowl-
edge status, to inform the caller that the call has
been diverted.
The radio then switches to the programmed call
diversion channel and transmits the sequence that
has been set up for the call diversion, without indi-
cating to the user that an incoming call has been
received (no ringing). After executing the diversion
transmission, the radio reverts to the channel it was
on prior to the call diversion.
Calling a Radio in Diversion Mode
Your radio may be programmed to respond to a
diversion status report when making a call. When it
detects the diversion status in the acknowledgement
from the radio it has called, it displays
DIVERT
, to
indicate that the call has been diverted. It then
switches to the programmed diversion channel.
Programmable
Channel
Signaling
Your radio may be programmed so that you can
change the subaudible signaling (CTCSS/DCS)
used on a channel. Up to 20 signaling presets may
be defined at radio programming time.
To Next Page
Loading...
Need help?
General
