User Function Menu 41
Changing the Channel Signaling
1. Press the function key ( ). The item last
viewed while in user function entry mode
appears in the control head display.
2. Use the up and down scroll keys ( / )
to move through the list of menu options until
the
PROG SIG
option is displayed.
Note: The
PROG SIG
option does not
appear if no subaudible signaling presets
were defined at radio programming
time.
3. Press the enter key (
)
to enter signal
programming mode. The name of the first
channel programmed in your radio is then
displayed.
4. Use the up and down scroll keys ( / )
to move through the list of channels until the
channel you wish to change is shown.
5. Press the enter key (
)
again to access the list
of signaling preset labels.
6. Use the up and down scroll keys ( / )
to move through the list of signaling presets.
7. When the preset you wish to apply to the
channel is displayed, press the enter key (
)
.
The channel is then updated with the new sig-
naling.
To Next Page
Loading...
Need help?
General
