Tait tm8200 User Manual

Operating in conventional mode 19
2 In the Channels menu, scroll through
the list of channels and groups until the
group you want appears.
3 Press Done.
The amber LED glows and the scanning
symbol appears in the display.
Selecting a group by using your Quick
Access menu
1 Press one of the scroll keys or to
open the Channels menu.
2 Scroll through the list of channels and
groups until the group you
want appears.
3 Press Done.
The amber LED glows and the scanning
symbol appears in the display.
Checking that a channel is clear
You or your user group may be segregated from other user
groups by special signalling. If an incoming call carries the
special signalling tones specific to you or your user group,
your radio’s signalling mute opens and you can hear the call.
These tones may not be audible.
The monitor function may allow you to override any special
signalling on a channel, so that you can check that the chan-
nel is clear before you make a call.
Note: Your radio may be programmed to activate monitor
whenever the microphone is off the microphone clip.
To activate monitor, you may be able to either:
■ remove the microphone from the microphone clip,
■ use a programmed function key, or
■ use the Main menu.

Tait tm8200 Specifications

General

Operating Temperature Range	-30°C to +60°C
IP Rating	IP54
Channel Spacing	12.5 kHz, 25 kHz
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz, 400-470 MHz